New sequencer module is out!

For discussion of the Voltage Modular synthesis ecosystem.
User avatar
marltetz
Posts: 58
Joined: Tue Feb 26, 2019 9:53 pm
Location: Tokyo, Japan
Contact:

Re: New sequencer module is out!

Post by marltetz » Sat Sep 19, 2020 10:05 pm

Okay, I first try "after the grid", then "before the grid." (When a note crossed a beat, it can be a challenge.)

"Micro timing for every note" is easier since it can be done without adding a new grid UI. :)
Then,
>a third view
It can be done by adding a state to the "CV/Prob" switch. Currently, the switch which changes the view of the grids between CV and Probability mode has two states and it will be three.

Another concern is a format of the value. Is it better to have discrete value (like 10%, 25%, 50%, 75%) or it should have continuous value (like ±1.0%~99.0%)?

User avatar
xuoham
Posts: 133
Joined: Tue Sep 03, 2019 10:30 am
Location: Ryû-Kyû, between Taiwan and Japan

Re: New sequencer module is out!

Post by xuoham » Mon Sep 21, 2020 5:00 am

Maybe increments of 5% would be more than enough, and easier to use than 0~100% ?

Three states switch seems like an elegant solution ! :D

User avatar
marltetz
Posts: 58
Joined: Tue Feb 26, 2019 9:53 pm
Location: Tokyo, Japan
Contact:

Re: New sequencer module is out!

Post by marltetz » Mon Sep 21, 2020 8:38 pm

Thanks for sharing your thought. :)
I want to do it before long.

User avatar
xuoham
Posts: 133
Joined: Tue Sep 03, 2019 10:30 am
Location: Ryû-Kyû, between Taiwan and Japan

Re: New sequencer module is out!

Post by xuoham » Tue Sep 22, 2020 12:34 am

On the contrary, thanks to YOU for such dedication ! :D

Sas2506
Posts: 7
Joined: Sun May 17, 2020 7:40 pm

Re: New sequencer module is out!

Post by Sas2506 » Sun Sep 27, 2020 12:46 pm

I cannot find G4 in quantized mode... is this a bug, or a problem with my system?

User avatar
marltetz
Posts: 58
Joined: Tue Feb 26, 2019 9:53 pm
Location: Tokyo, Japan
Contact:

Re: New sequencer module is out!

Post by marltetz » Mon Sep 28, 2020 12:37 am

Hi,

Sorry for inconvenient.
You can set finer value by "Drag with RMB" on the grid.
First, set rough value with LMB click, then fine-tune with RMB drag.

Currently, it can happen on any of zoom setting because the size of grid is relatively small compared to its internal voltage value.

Sas2506
Posts: 7
Joined: Sun May 17, 2020 7:40 pm

Re: New sequencer module is out!

Post by Sas2506 » Mon Sep 28, 2020 3:37 pm

Yes, that works fine - thank you!

User avatar
marltetz
Posts: 58
Joined: Tue Feb 26, 2019 9:53 pm
Location: Tokyo, Japan
Contact:

Re: New sequencer module is out!

Post by marltetz » Mon Sep 28, 2020 7:27 pm

:)

Post Reply