Cherry Audio Forums

OK, so it turns out there were a couple little glitches in 1.0.0. The worst one was that the stand-alone Voltage Modular application would forget its MIDI device settings every time you exited. Whoops. We also found and fixed a sneaky little crash that was possible when using multiple Voltage Modular instances in a DAW, but it was very difficult to get the crash to occur.

To download Voltage 1.0.2, follow these steps:

1) Log in to your account at https://store.cherryaudio.com/
2) Click on Library in the upper-right hand corner.
3) Find your Early Access Voltage Pack order and click on "Details" on the far right.

You'll see the new 1.0.2 download links. Otherwise, next time you run Voltage Modular, it'll probably download the update for you automatically.

Thanks everyone for your feedback!

All the best,
Dan

Thanks Dan!
Where can we find the change log for every version?
thanks!
a.

+ 1 for a log!

Small nitpick, but I noticed that MIDI Input device apparently uses low-res assets when compared to other modules (open in new tab and click to zoom in):

https://i.imgur.com/vlDwafH.png

Compare the module's header, device status part, labels on the sockets or even the Cherry Audio logo on the bottom

antic604 wrote: ↑Mon Sep 24, 2018 7:43 pm Small nitpick, but I noticed that MIDI Input device apparently uses low-res assets when compared to other modules (open in new tab and click to zoom in)

Thanks Antic. We've published an update to the MIDI Input module, which adds a Sustain output and is switchable between Single & Multi Trigger. It also fixes the background issue. Thanks for bringing this to our attention!

Dan

Cherry Dan wrote: ↑Tue Sep 25, 2018 12:01 amWe've published an update to the MIDI Input module, which adds a Sustain output and is switchable between Single & Multi Trigger. It also fixes the background issue. Thanks for bringing this to our attention!

Awesome! Thanks