Cherry Audio Forums

I'm bummed that there are so few stereo filters in the VM collection. Of the 30 or so that I own (because I need them okay?), only four have stereo I/O. Lots of interesting filters, but mostly mono. Sure I can use two in parallel, but that's awkward and fiddly. A filter is often used to process a more developed signal, and for me a more developed signal often means stereo. Thoughts?

you are totally correct. there's far too few stereo modules and especially filters. that's why i try to add stereo as best as i can.
for now here's an array of Micro Module filters: and of course some ported Airwindows Filters and EQs that are also stereo:
there'll be more stereo modules in the future, but for now that's all of my stereo filters i can think of from the top of my head. hope this helps

The Adroit Tandem module allows the controls of two mono filters to be bi-directionally linked so that adjusting a control on one filter automatically changes the setting of the matching control on the other filter.

It can be a bit of a pain to set up but once done you effectively have a stereo filter.

In the example below the two stock filter's CUTOFF, RESONANCE, FREQ MOD 1, RES MOD knobs and the SLOPE buttons are linked.

ColinP wrote: ↑Fri Jan 31, 2025 11:54 am The Adroit Tandem module allows the controls of two mono filters to be bi-directionally linked so that adjusting a control on one filter automatically changes the setting of the matching control on the other filter.

I was completely unaware of this module until now. Instabuy!

For what it's worth, I have a stereo filter in development. Don't want to say what, because someone who codes faster than I do would promptly come out with one.

Reid