Cherry Audio Forums

Hi i am trying to use the sequence presets for the vm modules and i cannot get them to sync with my project . The sequence starts at different places and is out of sync. I know it is the rate i tried using a clock divider but that did nothing. Any suggestions would be most welcome

VM2500:

• Select the OFF button.

• Send a clock signal to the STEP input connector

To reset to the first step just send a trigger signal of your choice
into the RESET input connector.

Almost the same for the VM900

• Set OSC.off

• Send a clock/trigger signal to the SHIFT input connector.

and so on...

Thanks