Cherry Audio Forums

I find the ideas behind your modules intriguing, and I have bought a bunch, but I am not getting out of them what I could. Please make more videos or patches, please.

Oh okay...

Give me a little time to make my way through the jungle of various projects to tackle this, but it's been looming on the todo list, and so it will be done! Any particular module seem like a good place to start?

playertron wrote: ↑Thu Sep 09, 2021 7:03 pm Oh okay...

Give me a little time to make my way through the jungle of various projects to tackle this, but it's been looming on the todo list, and so it will be done! Any particular module seem like a good place to start?

Thank you. Maybe start with infrastructure bundle. Also, I have been demoing stratacorder, but I cannot figure out a way to reset the device in a way that clears out all the current sounds.

Even just the patches from all of those screen shots of your devices would be super helpful.

Here's a little intro to the Voltage Source Panel and the MIDI Actuator:

https://www.loom.com/share/1ffe232f2430 ... ea55f20c6c

And here's a patch:

Here's an intro to the Time Scattering Device:

https://www.youtube.com/watch?v=j7e5tD2Ilq8

And here are some template-style presets that'll get you going with it:

Hopefully this helps save someone a little setup time:
This is a preset for the Signal Conversion Framework (https://store.cherryaudio.com/bundles/s ... -framework) that sets up a full 32-bit analog to digital to analog conversion, through the Sample Rate Reducer. It is set up with full fidelity, which means it doesn't really do anything - same as a wire from input to output. But, you can start dropping bits, reducing rates, making the conversion nonlinear, etc. by adjusting the controls. The preset routes the Audio Source jacks, but move that to the output of your synth setup if you like. Minor adjustments can essentially simulate real world imperfect conversions, while drastic settings get into bit crushing, lofi, distortion, noise...