Page 1 of 1
In stand alone mode, how do you start the transport?
Posted: Wed Jul 14, 2021 3:52 pm
by Winslow Schiller
Subject says it all. It's easy as a plug in via a DAW, but I'm not seeing a 'play' type button/control in stand alone. Thanks,
Winslow
Re: In stand alone mode, how do you start the transport?
Posted: Wed Jul 14, 2021 4:13 pm
by huggermugger
You have to create your own "transport". First, patch the Sync out to a Sync Divider to get your clock signal, which you then patch into the Ext Clock of your sequencer(s). Then patch button controls to the Start and Stop inputs of the sequencer(s). You should also patch the Reset to keep things aligned. The Tempo is set at the top.
Re: In stand alone mode, how do you start the transport?
Posted: Wed Jul 14, 2021 5:46 pm
by Winslow Schiller
Perfect, thanks. - Winslow