How is Parameter 5 Output Select handled in Cherry Chroma?

Cherry Audio’s Chroma synthesizer is a stunning virtual instrument that meticulously revives the essence and sonic capabilities of the legendary Rhodes Chroma.
Post Reply
timg11
Posts: 13
Joined: Sun Dec 25, 2022 5:39 pm

How is Parameter 5 Output Select handled in Cherry Chroma?

Post by timg11 »

Related to previous post from @nuSoniq, how is Parameter 5 Output Select handled in Cherry Chroma?

I made a "pseudo-stereo" modification to my voice cards. For the algorithms where AMP A and AMP B are summed (1, 2, 3, 13, 14, 15) I swapped output bus 1 and 2, so AMP A went to Out 1, and AMP B went to Out 2.

Because of this many of my patches are stored with Output Select set to 1. My physical Chroma connection has the main output to a center panned channel, and Output 1 and 2 to a stereo channel.

I'm finding some of my legacy patches are not making any sound in Cherry Chroma. I went to verify the Output Select parameter, and don't find it anywhere. I searched through the manual, and did not find it mentioned. How are patches with Output Select set to non-zero values handled in Cherry Chroma?
mate_stubb2
Posts: 1
Joined: Sat Jun 22, 2024 2:42 am

Re: How is Parameter 5 Output Select handled in Cherry Chroma?

Post by mate_stubb2 »

The Output Select is not supported in Cherry Chroma. That doesn't answer the question of how non channel 0 saved values are handled though.

Seems like the desired behavior should be all non zero values from imported files should be reset to 0.

Perhaps submit as a feature request?
Post Reply

Return to “Chroma”