I just got the automatic update for the MS Vintage Bundle in VM - Many thanks for that CA
There is an issue with the dual oscillator though. On the gui/panel it shows a +/-5 semi tone range for the osc2 pitch control knob, when in fact it allows up to +/-12 semi tones.
VCO-20 dual osc issue
- honki-bobo
- Posts: 306
- Joined: Sat Nov 09, 2019 1:18 pm
- cherryaudio Greg
- Site Admin
- Posts: 839
- Joined: Wed Aug 29, 2018 5:06 pm
Re: VCO-20 dual osc issue
Hi,
Good catch! Thanks for reporting this.
Greg
Good catch! Thanks for reporting this.
Greg
- cherryaudio Greg
- Site Admin
- Posts: 839
- Joined: Wed Aug 29, 2018 5:06 pm
Re: VCO-20 dual osc issue
Hi again,martb wrote: ↑Sat May 15, 2021 9:15 am I just got the automatic update for the MS Vintage Bundle in VM - Many thanks for that CA
There is an issue with the dual oscillator though. On the gui/panel it shows a +/-5 semi tone range for the osc2 pitch control knob, when in fact it allows up to +/-12 semi tones.
It turns out that this is the way the original hardware worked. We've updated the documentation to clarify:
"The front panel of the original MS-20 is labeled -5 to +5, but its range was actually around an octave either way, so we've done the same here - VCO-20's detune range is just over an octave up or down."
Greg
Re: VCO-20 dual osc issue
Oh, ok - Thanks.cherryaudio Greg wrote: ↑Mon May 17, 2021 9:27 pmHi again,martb wrote: ↑Sat May 15, 2021 9:15 am I just got the automatic update for the MS Vintage Bundle in VM - Many thanks for that CA
There is an issue with the dual oscillator though. On the gui/panel it shows a +/-5 semi tone range for the osc2 pitch control knob, when in fact it allows up to +/-12 semi tones.
It turns out that this is the way the original hardware worked. We've updated the documentation to clarify:
"The front panel of the original MS-20 is labeled -5 to +5, but its range was actually around an octave either way, so we've done the same here - VCO-20's detune range is just over an octave up or down.