New module release: Trigger Gate Converter (TGC)

Post Reply
User avatar
honki-bobo
Posts: 305
Joined: Sat Nov 09, 2019 1:18 pm

New module release: Trigger Gate Converter (TGC)

Post by honki-bobo »

Convert Triggers to Gates and Gates to Triggers

The new Trigger Gate Converter (TGC) is actually two modules in one:

The part above the monkey converts gate signals to triggers with dedicated outputs for the rising and the falling edge of the gate.

The part below the monkey converts trigger signals to gates, where the timing of the gate output signal is determined by the TIME parameter. If TIME is set to 0.0 ms the trigger changes the state of the gate, i.e. if the gate output is low an incoming trigger will change it to high and if the gate output is high an incoming trigger will change it to low.

time diagram t0.png
time diagram t0.png (181.67 KiB) Viewed 1743 times

If TIME is greater than 0.0 ms a trigger will open the gate for the set amount of time.

time diagram t100.png
time diagram t100.png (181.17 KiB) Viewed 1743 times

If a new trigger occurs before the gate has been closed, it will stay open and the timer will start again from zero.

time diagram t600.png
time diagram t600.png (181.14 KiB) Viewed 1743 times

TIME can also be controlled by pitch CV following the 1 V/octave rule. The gate will be opened for the duration of a single cycle at the corresponding pitch, where a 1/16th note at 120 BPM equals about -3.03135971V. This allows for tempo-synced gating.

An input signal is considered high if it is greater than or equal to 2.5 V and considered low if it is less than 2.5 V.

The Trigger Gate Converter is now available in the Cherry Audio store.

Best regards,
Martin
Image
Monkey Business Audio
Modules - Music - Twitter - YouTube
Post Reply

Return to “Monkey Business Audio”