Page 1 of 1
Posted: Wed Jun 03, 2020 7:36 am
VCO2 - double click fine tune for default goes to 0.06 not 0. VCO goes to 0. Is this a defect or a replica of some behaviour?
Posted: Wed Jun 03, 2020 4:06 pm
It's by design so that the two oscillators start off slightly detuned from one another.
Posted: Thu Jun 04, 2020 9:31 am
Suspected as much.
But I like to double click to reset to default of 0. Ah well, one can't have everything - unless, is there a way to set the default value to a value of ones own?
Posted: Wed Jun 24, 2020 2:50 am
right click it/module preset?