Page 1 of 1

Sync VM2500 sequencer to DAW

Posted: Sun Apr 18, 2021 8:37 am
by MRBarton
Here's a method (although somewhat strange) which will sync the 1027 sequencer to a host DAW and it uses only stock modules. It is necessary to get the RATE control in the vicinity of the desired tempo and the clock will stay synced over an almost 2 to 1 range without readjustment. The preset as shown will sync from 90 to 140bpm. Outside that range, just turn the RATE control to re-capture.

We could have changed the 1027 to be more modern, but we wanted all the modules to be as authentically vintage as possible. If we change too much, it's not a 2500 any more. Remember, nobody was syncing to DAWs 50 years ago, so be thankful that VM has the modules to make this work. There are probably other methods as well. This is just the first one I found that was successful.

Re: Sync VM2500 sequencer to DAW

Posted: Mon Apr 19, 2021 4:58 am
by HowlingMod
thanks!

great stuff by the way!!

Re: Sync VM2500 sequencer to DAW

Posted: Sat Apr 24, 2021 7:36 am
by farbstoff-fabrik
https://www.facebook.com/groups/2689074 ... 906829460/

I came up with that solution. It is a bit of a workaround, but it does the job.

Have fun,

Cheers,

Matthijs Vanamsterdam